Technicolor - Thomson ST516V6 Manuel d'utilisateur télécharger pdf (Page 41)

E-DOC-CTC-20060911-0017 v2.0

Chapter 4

Troubleshooting

4.6 Reset to Factory Defaults

Resetting your Thomson Gateway

You might consider a reset to factory defaults as described below.

A reset to factory default settings deletes the configuration profile settings. Therefore, after the reset, a

reconfiguration of your Thomson Gateway will be needed.

Reset to default configuration

Proceed as follows:

1 Make sure the Thomson Gateway is turned on.

2 Use a pen or an unfolded paperclip to push the recessed reset button on the back panel. The reset button

is marked with a red circle. Push it until the power LED lights red - this will take about 7 seconds.

3 Release the reset button.

4 The Thomson Gateway restarts.

Be aware that a reset to factory defaults will revoke all configurational changes you made to the

Thomson Gateway.

DSL Reset ON/OFFEthernet

1 2 ... 36 37 38 39 40 41 42 43 44

Pas de commentaire

Technicolor - Thomson ST516V6 Manuel d'utilisateur Page 41